Balluff BAE011H, User Manual, Page: 94 / 118

www.balluff.com
34
Command Menu
INPUT 1 ACTION
(function Input 1)
This parameter defines the function of the input “Ctrl. In 1”.
(s) =
static switching (level evaluation), INPUT CONFIG must be set to active LOW /
HIGH
(d) =
dynamic switching (edge evaluation), INPUT CONFIG must be set to
RISING/FALLING EDGE
0 NO
No function
1 RESET/SET VALUE
Power-failure-proof stored transfer of the current
position or angle measurement to the "Offset"
parameter.
(d) (s)
2 FREEZE
Freezing of the current measurement result
(s)
3 TEACH ANALOG START
Transfer of the current measurement result in the
parameter "Analog Start"
(d)
4 TEACH ANALOG END
Transfer of the current measurement result in the
parameter "Analog End"
(d)
5 TEACH PRESELECTION 1
Transfer of the current measurement result into the
parameter "Preselection 1"
(d)
6 TEACH PRESELECTION 2
Transfer of the current measurement result into the
parameter "Preselection 2"
(d)
7 TEACH PRESELECTION 3
Transfer of the current measurement result into the
parameter "Preselection 3"
(d)
8 TEACH PRESELECTION 4
Transfer of the current measurement result into the
parameter "Preselection 4"
(d)
9 TEACH PRESELECTION 5
Transfer of the current measurement result into the
parameter "Preselection 5"
(d)
10 TEACH PRESELECTION 6
Transfer of the current measurement result into the
parameter "Preselection 6"
(d)
11 RESET MIN/MAX Reset the minimum / maximum value
(d) (s)
12 LOCK RELEASE Release latching of all outputs
(d)
13 SERIAL PRINT Sending of serial data, see parameter SERIAL VALUE
(d)
14 ACTIVATE DATA N.A.
15 STORE DATA N.A.
16 TESTPROGRAM
N.A.
17 CLEAR LOOP TIME Reset of the maximum “Loop Time”
(d)
18 FACTORY SETTINGS Device is reset to factory settings
(d)