Screws
Front Panel
1. Remove the grille
1) Open the front panel.
2) Take out the screws in the grille.
3) Hold the both sides of the grille, dragging towards
oneself and then remove it.
2. Remove the electrical control box
1) Remove the indoor coil sensor from the sensor bracket.
2) Remove the switching board.
3) Take out the screws of the terminal board then Remove the
terminal board.
4) Disconnect all the circuitry of the printed circuit board.
5) Remove the printed circuit board and check-up it.
6) Disconnect the circuitry in the electrical control box.
7) Remove the printed circuit board.
8) Take out the screws of the electrical control box and
remove the electrical control box.
3. Remove the air outlet frame
1) Take out the screws of the stepper motor and disconnect
the stepper motor and the air outlet frame.
2) Remove the stepper motor.
3) Disconnect the drainage hose and the air outlet frame.
4) Take out the screws of the air outlet frame.
5) Remove the air outlet frame.
KFR-3601G/BPE KFR-4001G/BPE
Indoor Coil Sensor
Screw
Screws
Terminal Board
Stepper Motor
Screws
Drainage Hose
Sensor Bracket
Screws
11. DISASSEMBLY INSTRUCTIONS
OPERATION PROCEDURE
PHOTOS
34
