40
41
About Z-Wave
About Z-Wave
ABOUT Z-WAVE
®
Z-Wave is a wireless mesh-networking protocol
for reliable, intelligent home control of all Z-Wave
compatible devices. Z-Wave devices can act as
repeaters to create a mesh-network to ensure reliable
communication regardless of the manufacturer or
type of device. This product can be included and
operated in any Z-Wave network with other Z-Wave
certified devices from any other manufacturer. Z-Wave
devices such as lamp modules, fan controllers,
thermostats, dimmer switches, and many other types
of home control devices are available from a wide
range of manufacturers. The Z-Wave Alliance (www.z-
wavealliance.com) provides a list of manufacturers of
Z-Wave compliant devices. Z-Wave was created by
Sigma Designs and more details on the technology
can be found at www.z-wave.com.
This product can be included and operated in any
Z-Wave network with other Z-Wave certified devices
from other manufacturers and/or other applications.
All nonbattery-operated nodes within the network
will act as repeaters regardless of vendor to increase
reliability of the network.
The current product controls may establish two
Association Groups. Association Group #1 is a
dedicated lifeline for secondary controls, primarily
used for battery status reports, central scene cc, local
reset cc. Association Group #2 is dedicated to slave
shades nodes, with a maximum of 12 slave nodes.
Normal shade control command will use Association
Group #2.
FCC Class B Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/television technician for help.
Modifications:
Any modifications made to this device that are not approved
by Springs Window Fashions may void the authority granted to the user by the
FCC to operate this equipment.
For advanced technical information, contact customer service
at 1-800-221-6352.
Battery Information for Shades
Use only eight AA lithium batteries, which are available through most hardware
stores, pharmacies, and home centers.
CAUTION:
Batteries must be installed as shown below. Failure to do so could
result in injury and will invalidate your warranty. Do not mix type, brand, or old
with new. Do not recharge, disassemble, heat (above manufacturer’s specified
temperature), or incinerate. Keep batteries out of reach of children and in
original packaging until ready to use. Dispose of batteries properly.
Correct battery orientation and proper battery disposal must be followed.
