P20 / P32 OPERATIONS MANUAL
Page | 6
Warning 7
When changing dies with the quick change tool, hold the handle as shown in the above figures. Make sure your
hand will not get between the dies!
COMMISSIONING
Oil fill
Fill the oil tank to center line of the indicators in the dipstick, with hydraulic oil like Shell Tellus T46 or equivalent.
Volume of the tank is 32 liters. It is recommended to pump the oil into the tank through a 20 µ filter, because new oil
in drums is not pure.
Electrical connection
CAUTION!
Check that the machine voltage (see type plate) is equal to your supply voltage. For proper installation to
local code. Consult a licensed contractor. Bring the supply cable, through the hole in the side panel of the electric box.
Secure the cable with a relief plug.
3-phase:
Connect the phase conductors to the respective L1, L2 and L3 terminals in the supply disconnecting
device. Connect
the earth connection to the ground terminal on the fixing plate. Check the connection against the
wiring diagram enclosed in the spare parts list. Check that the motor rotation is parallel with the arrow on the tank
close to the motor. In case the motor rotates in wrong direction, two phase conductors in the supply disconnecting
device must be interchanged.
1-phase:
Connect the phase and the neutral to the respective terminals in the supply disconnecting device.
Connect the earth connection to the ground terminal on the fixing plate. Check the connection against the wiring
diagram enclosed in the spare parts list.
