e.Video length
Use the up/down buttons to select the length of the video recording (between 5–30 seconds) that is to be
made when video recording is activated. The longer the recording time selected, the shorter the operating
time.
f.Interval
Inpute the minimum time period(between 3second and 60mins) that the camera should wait before
reacting to subsequent activation of the sensor after the initial recording. During the selected interval, the
camera will not record any images or videos. This prevents the memory card from being filled up with too
many recordings of the same event. You can select between 3 seconds to 60 minutes.
g.Shot number.
Select the number of photos that are to be taken in succession when the camera is activated in photo
mode. In addition to single shot mode 1 photo, you can take“2 photos”or“3 photos”.
h.PIR Sensitivity
The sensitivity of the main motion sensor is set here. For interior areas and environments with little
interference, such as branches blowing in the wind, select“High”. Select“Medium”for exterior areas and
environments with a normal amount of interference, and select“Low”for environments with a high level
of interference. The temperature can also affect the sensitivity. The“High”setting is suitable for warm
ambient temperatures, whereas“Low”should be selected for cold environments.
i.Date stamp
Here you can choose whether to save your photos with a time stamp.You can choose whether the stamp
consists of the time and date or just the date.
j.MMS status
Choose either VGA=640x480 or QVGA=320x240, which defines the resolution size of the MMS picture.
k.Record audio
Open the function, you can record sound while recording video.
l.Timer
Select“On”if the camera should only be active during a certain time period. In the screen menu that
subsequently appears, you can then set the start and end time for the active phase:
