Care2
Installation Instructions
Care2 issue 7
21
Figure 2.23 — Red RJ45 Link Between Network and Line Card
9. The YELLOW RJ45 cable should be connected to the Fire
Panel connector on the Front Panel board as shown in Figure
2.24.
Ensure the new cable is fitted behind the existing cables and
secured to the existing loom using the cable ties provided.
Figure 2.24 — C2CN Connections to Front Panel
2.4.1 Setting Network Address
1. Clear Device Assignments (refer to Section 7.6 on page 81).
2. Set the Network Address (refer to Section 4.9 on page 55).
3. Perform the Internal Device Detection Procedure (refer to
Section 4.4 on page 43) and ensure it is successful.
N
OTE
: The Network Address is normally set during Commissioning.
To manually set the Network Address use this procedure.
N
OTE
: Network Communication bewtween Panels may fail and Faults
may not be reported correctly if the Network Address is not set.
