Baldor VS1MXS series, Installation & Operating Manual

Page: 59 / 88

Customizing Your Application 8-1 MN762S
Chapter 8
Customizing Your Application
8.1 Simple Parameter Adjustments
Factory settings may give satisfactory performance, however certain adjustments may be beneficial.
Table 8-1
Adjustment Parameter Parameter Name
Motor Rated Volts P1-01
The factory default setting P1-01 = 575 should be used unless
voltage compensation is required.
Motor Rated
Current
P1-02
Must be set to the value on the motor nameplate.
P1-04 is optional. If this parameter is set to zero (default state),
speed is displayed in Hz (otherwise, RPM).
Motor Rated
Frequency
P1-03
Motor Rated
Speed
P1-04
Minimum Speed P1-05
Set P1-06 to the maximum speed and P1-05 to the minimum
speed. These limits can also be negative for reverse speeds.
If a non-zero minimum speed is set in P1-05, the motor will
ramp to this minimum speed at the rate set in P1-10 as soon
as the drive is enabled.
Maximum Speed P1-06
Start/Stop Source P1-07 Set as required by the application.
Speed Ref Source P1-08 Set as required by the application.
Stop Mode P1-09 Select method of stopping required when drive is disabled.
Acceleration
Ramp
P1-10
Adjust as need for your application. Short Acceleration or
Deceleration times may cause excess motor current and may
result in it tripping or the motor stalling.
Deceleration
Ramp
P1-11
Analog Input
Format
P2-30 Set as required by the application (0-10V, 10-0V, 4-20mA)