background image

Section 2

General Information

General Information  2-1

MN2403

Thank you for purchasing your Baldor Generator Set.  This manual contains information you need to safely and

efficiently install and operate your generator set. During the preparation of this manual every effort was made to

ensure the accuracy of its contents.  This manual describes only very basic engine information. A separate owner’s

manual for the engine is supplied with this unit for your use. Please refer to the engine manual for information

relative to engine operation, maintenance, recommendations and additional safety warnings.

Copyright Baldor 

©

 2004. All rights reserved. 

This manual is copyrighted and all rights are reserved. This document may not, in whole or in part, be copied or

reproduced in any form without the prior written consent of Baldor Electric Company, Inc.
Baldor Generators have earned the reputation of being high quality and dependable. We take pride in this fact and

continue to keep our quality standards high on our list of priorities. We are also constantly researching new

technological ideas to determine if they could be used to make our generator sets even better.

Baldor makes no representations or warranties with respect to the contents hereof and specifically disclaims any

implied warranties of fitness for any particular purpose. The information in this document is subject to change

without notice. Baldor assumes no responsibility for any errors that may appear in this document.

Limited Warranty

Baldor Generators will replace or repair free of charge any part or parts of the generator of their manufacture that

are defective in workmanship and materials for a period of time as set forth in the Warranty Period chart below.  

All Baldor products requiring warranty service shall be transported or shipped freight pre

paid, at the risk of the

party requiring warranty service, to a Baldor Generator repair facility, or to Baldor Generators 

 Customer Service

Department in Oshkosh, Wisconsin. Written notification of the alleged defect in addition to a description of the

manner in which the Baldor generator is used, and the name, address and telephone number of the party requiring

warranty service must be included.  Baldor is not responsible for removal and shipment of the Baldor product to the

service center or for the reinstallation of the Baldor product upon its return to the party requiring warranty service.

Problems with Baldor products can be due to improper maintenance, faulty installation, non

Baldor additions or

modifications, or other problems not due to defects in Baldor workmanship or materials.  If a Baldor Generator

repair facility determines that the problem with a Baldor product is not due to defects in Baldor workmanship or

materials, then the party requesting warranty service will be responsible for the cost of any necessary repairs.

EXCEPT FOR THE EXPRESSED WARRANTY SET FORTH ABOVE, BALDOR GENERATORS DISCLAIMS ALL

OTHER EXPRESSED AND IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF FITNESS

FOR A PARTICULAR PURPOSE AND MERCHANTABILITY. NO OTHER WARRANTY,  EXPRESSED OR

IMPLIED, WHETHER OR NOT SIMILAR IN NATURE TO ANY OTHER WARRANTY PROVIDED HEREIN, SHALL

EXIST WITH RESPECT TO THE GOODS SOLD UNDER THE PROVISIONS OF THESE TERMS AND

CONDITIONS.  ALL OTHER SUCH WARRANTIES ARE HEREBY EXPRESSLY WAIVED BY THE BUYER.

UNDER NO CIRCUMSTANCES SHALL BALDOR GENERATORS BE LIABLE OR RESPONSIBLE IN ANY

MANNER WHATSOEVER FOR ANY INCIDENTAL,  CONSEQUENTIAL OR PUNITIVE DAMAGES, OR

ANTICIPATED PROFITS RESULTING FROM THE DEFECT, REMOVAL, REINSTALLATION, SHIPMENT OR

OTHERWISE.  This is the sole warranty of Baldor Generators and no other affirmations or promises made by

Baldor Generators shall be deemed to create an expressed or implied warranty.  Baldor Generators has not

authorized anyone to make any representations or warranties other than the warranty contained herein.

Warranty Period

Generator Series

Labor*

Parts

Portable Products 

(Premier, Powerchief, DG Series, K Series)

1 Year

3 Years

Towable Products (TS)

1 Year or 3,000 Hours

Whichever comes first

3 Years or 3,000 Hours

Whichever comes first

3600 RPM Standby Systems

(Some AE Models)

1 Year or 1,000 Hours

Whichever comes first

3 Years or 1,000 Hours

Whichever comes first

1800 RPM Standby Systems

(Some AE Models, DLC, GLC)

1 Year or 3,000 Hours

Whichever comes first

3 Years or 3,000 Hours

Whichever comes first

Industrial Standby Systems

1 Year or 1,000 Hours

Whichever comes first

2 Years or 1,000 Hours

Whichever comes first

Industrial Prime Power Systems

1 Year or 1,000 Hours

Whichever comes first

1 Year or 1,000 Hours

Whichever comes first

International

1 Year or 1,000 Hours

Whichever comes first

1 Year or 1,000 Hours

Whichever comes first

*For products covered under labor coverage, travel expenses will be allowed up to 7 hours straight labor or 300

miles, whichever occurs first and only applies to permanently wired and mounted products (AE, DLC, GLC, IDLC).

No warranty registration card is necessary to obtain warranty on Baldor Generators.

You must save the purchase receipt.  Proof of purchase, date, serial number and model number will be required for

all portable and Towable products to qualify for any warranty consideration.

For all other products, a start

up inspection form/warranty registration must be completed in its entirety and

submitted to Baldor Generators within 30 days of start

up to qualify for any warranty consideration.

Summary of Contents for PC32RI





























Reviews: