6
CAUTION! Disconnect motor leads (U, V, and W) from control before performing a
“Leakage Resistance” test on the motor. Failure to disconnect motor
from the control may result in extensive damage to the control. The
control is tested at the factory for high voltage / leakage resistance as
part of Underwriter Laboratory requirements.
CAUTION! Suitable for use on a circuit capable of delivering not more than 5,000
RMS symmetrical short circuit amperes listed here at rated voltage.
CAUTION! Proper shielding, grounding and filtering of this product can reduce the
emission of radio frequency interference (RFI) which may adversely
affect sensitive electronic equipment.
CAUTION! Do not use the “115V” position for 230 Volt AC line input voltage.
Damage will occur to the drive. The 115V position provides 2 times the
AC input voltage to the motor.
CAUTION! GFCI Operation: Do not connect this drive to an AC power source
controlled by a ground-fault circuit-interrupter.
CAUTION! If the current limit is adjusted above 160% of the motor nameplate
rating, this can cause overheating of the motor.
CAUTION! Do not leave the motor in a locked rotor condition for more than a few
seconds since damage may occur.
Summary of Contents for NEMA 1 / IP40
Page 18: ...18 Figure 2 3 Drive Layout...