5
TYPICAL INSTALLATIONS
INSTALLATION
Remove pump from carton and attach to cover,
bung fitting or other mountings.
Blow out any foreign material from the air supply
line before connecting to pump. An air line
filter/regulator is recommended for all applications;
wet and dirty air will shorten the life of the pump.
NOTE:
For severe duty applications, an air line
lubricator is recommended for better performance
and longer pump life. Use an SAE 10 oil and set
the lubricator for 2 drops per hour.
Be sure the air supply is OFF before connecting
accessories and/or pump.
NOTE:
DO NOT
hang Filters/Regulafors/
Lubricators or other equipment of this type directly
from pump air inlet. The fittings are not strong
enough to support the weight and may cause one
of more to leak and/or break. A bracket should be
used to support the use of these products.
CAUTION:
If you are not using a
low-level cut-off at the pump fluid intake, install
a pump runaway valve to shut off the air to the
pump, when the pump accelerates beyond the
pre-adjusted setting. A pump that runs too fast
can be seriously damaged.
1. Install an air line regulator to control pump
speed and air pressure for the system.
2. Install an air line filter to remove and trap
contaminates that could cause unwanted wear
and tear on pump air motor.
3. Install a quick disconnect coupler to relieve
air pressure between the pump air motor and
regulator for servicing purposes later.
4. Install fluid hose, making note of fluid and
pressure compatibility of hose.
Figure 3
Drum Installation
Figure 4
Wall Mount Installation
Kit (4411-008)
A
Fluid OUtlet
B 1:3 to 1 Ratio Pump
C Air Regulator
D Air Filter/Separator
E Shut Off Valve
F
Air Supply
H Pressure Relief Valve
A
B
C
D
E
F
H
A
B
C
D
E
F
H
!
