4
3) Attach front wheel and bottom part of tee
handle to the front wheel bracket. With the
curve of the tee handle turned to the truck
drain, align the tee handle, bracket and wheel
so that the 5” long bolt will slide through all.
Tighten with lock nut. (See Figure #3)
figure #3
4) Attach top part of tee handle. Slide upper
tee handle onto lower part and slide bolt
through all, then tighten with lock nut. (See
Figure #4)
figure #4
5) Install a closing connector (I.E. ball valve
or dry break coupler). Place grill on truck
drain.
2) Attach front bracket. Slide bracket onto pin
located on the front of the truck drain with
forks facing forward. Insert cotter pin through
hole and bend ears back. (See Figure #2)
figure #2
1) Attach the two back wheels. Slide the 2”
long bolt through sleeve and insert through
wheel. Thread bolt into nut which is pre-
attached on truck drain frame. (See Figure
#1)
figure #1
aSSeMbLy
!
WarnInG
Never remove the grill or
insert a finger into the drain
port when vacuum evacuation of the
contents is being performed
.
Caution
!
This rolling truck drain is intended for
use only on flat horizontal surfaces.
Sloped surfaces can cause the rolling
truck drain to move out of position.
!
WarnInG
Do not lift this product with-
out mechanical assistance
.
Summary of Contents for 4120-001
Page 6: ...6 Notes...
Page 7: ...7 Notes...
