GENERAL
This electronic lube meter is designed specifically to dispense
motor oils (S.A.E. 80-140), automatic transmission fluid,
and antifreeze (Ethylene Glycol) solution. Perfect balance,
lightweight, ruggedness, and comfortable grip make it the
best choice for overhead reel systems.
The electronic register module can be programmed to
dispense in pints, quarts, liters, or gallons and will totalize
in liters or gallons. A calibration factor and unit of measure
are programmed during factory test. A 5-digit liquid crystal
display, accurate to the second decimal place, shows the
exact amount of fluid dispensed.
Caution:
1) Always read and follow the fluid manufacturers’s
recommendations regarding the use of protective
eye wear, clothing, gloves, and other personal
equipment.
2) Never alter or modify any parts of this product;
doing so may cause damage and/or personal
injury.
!
Do not place your hand or fingers over the
dispensing nozzle and/or aim the nozzle at
a person at any time. Personal injury may
result.
WARNING
!
GENERAL SAfETy
Always use the following
Pressure Relief Procedure
whenever shutting off, cleaning, or in any way
checking or servicing the control handle:
1) Disconnect compressed air line or turn off power
supply at the fluid pump.
2) Point the control handle outlet into a waste
container and open trigger to relieve pressure.
3) Open any bleed-type supply air valves and fluid
drain valves in the system.
4) Leave the drain valves open until you are ready to
re-pressurize the system.
WARNING
!
WARNING
!
DANGER:
Not for use with fluids that
have a flash point below 100°F ( 38°C,
examples: gasoline, alcohol). Sparking
could result in an explosion which could
result in death.
IMPORTANT
!
Read these safety warnings
and instructions in this manual
completely, before installation
and start up of the control handle.
It is the responsibility of the
purchaser to retain this manual for reference. Failure
to comply with the recommendations stated in this
manual will damage the control handle and void factory
warranty.
WARNING
!
Airborne particles and loud noise
hazards.
Wear ear and eye protection.
OPERATION
Depressing the ON/RESET button before each use resets
the totalizer to zero. Squeezing the trigger handle dispenses
the fluid.
The total amount of fluid dispensed from inventory can be
checked periodically by depressing the TOTAL button. If the
units dispensed are pints, quarts, or gallons, the totalizer
will read in gallons. If the units dispensed are liters, the
totalizer will read in liters.
DISPLAy fUNCTIONS
Sleep Mode
To extend battery life the display will go into “sleep” mode
if it has not been used for 2 minutes. The display can be
“woken” by pressing the ON/RESET button.
Total Button
Pressing the TOTAL button will toggle the LC Display
between the Batch and Total Displays. The Batch display can
be reset, the Total display is not re-settable.
On/Reset Button
If no data is shown on the LC Display, press the ON/RESET
button, this will “wake” the display.
The ON/RESET button is used to reset the Batch Total
to zero.
To Reset the Batch Display
Press the TOTAL button until the Batch display is shown.
The Batch display can be reset to zero by pressing and
releasing the ON/RESET button.
!
Maximum fluid Pressure 1000 PSI. Under no
circumstances should the control handle be
aimed at any person or your own body at anytime.
Personal injury may result.
CAUTION
