Instructions for Use
56
• Remove the diffusion sleeve and connect
the air expulsion tube to the accessory.
• The accessory has two holes on the side
to fit it to the window / balcony with. The
user can secure it to the frame or wall
with two screws (not included with the
accessory) to prevent it from moving or
falling out of place, Fig. 14.
Fig. 14
Notes:
Do not extend the hot air expulsion
tube more than necessary (maximum
length; 140 cm).
Do not form sharp bends when
positioning the tube, otherwise the Do
not form sharp bends when positioning
the tube, otherwise the correct
expulsion of hot air may be impeded.
This may cause a reduction in the
cooling power and performance of the
appliance.
In order to achieve maximum cooling
efficiency and minimum noise levels, the
expulsion tube should be fitted above the
total height of the appliance, Fig. 16.
a
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaa
aaa
aaaaaa
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaaa
a
a a a aaa
a
aaa
aaaaaa
aaa
aaaaa
24 - 38 cm
.
14 cm
.
Fig. 15
Permanent installation
Performed using the wall grommet
accessory. See "Description of
accessories".
• To expel hot air through the wall, it is
necessary to make an 14-cm diameter
hole in the wall and fit the wall grommet,
Fig. 15.
90
°
0
°
Fig. 16
Turning the appliance on and off
Press the "On" / "Off" key , to start the
appliance.
Warning!
Make sure that the appliance is plugged
into the mains electricity supply.
