background image

21.  Thread the rope through the pulley attached to the black 

Tri-Loop with pulley on the same side of the Reformer as the 
riser and pull back toward the riser Figure M.

22. Thread the rope through the upper, outer pulley on the 

riserblock and pull back toward the carriage Figure N. See 
Figure O for a detailed view of the riser pulley rope routing.

23. Using a Soft-Touch connection Figure P, secure each end of 

the rope to a grey Tri-Loop on the same side of the Reformer 
as the riser.

24. Repeat steps 20-23 for the other side of the Reformer.

IMPORTANT SAFETY NOTE:

 Use of the Konnector system in a manner for which it is not intended may result in equipment damage 

and/or injury to the user. Intense cardio work utilizing jarring movements may overload the system. Balanced Body is not responsible 
for injuries caused by equipment misuse.

Questions? Call Balanced Body Technical Support at 1-800-PILATES (US and Canada), or +1-916-388-2838 (all other countries).

WARNING: Using the existing shoulder posts with a Konnector system can cause the loops to fall off the posts during use which 

may cause serious injury.

Figure N

Figure M

Figure O

Figure P

Contact Us

1-800-PILATES | +1-916-388-2838

pilates.com | [email protected]

400-454  | 10.24.18

Summary of Contents for Rialto with Riser Konnector

Page 1: ...GEN6671 4 1 4 Flat Washer GEN9204 6 1 4 20 Hex Nut GEN9056 6 1 4 20 Acorn Nut GEN9181 2 5 16 Drill bit TOL1059 1 3 32 2 5 mm Allen wrench TOL1605 1 5 32 Allen wrench GEN9282 1 7 16 Wrench 616 113 1 WARNING Using the existing shoulder posts with a Konnector system can cause the loops to fall off the posts during use which may cause injury REMOVE ROPES SHOULDER BRACKETS AND PADS 1 Remove the ropes a...

Page 2: ...ood screws provided in the kit to finish securing the bracket in place Repeat for other side 9 Turn the carriage back over onto its wheels and place it on the rails with the headrest toward the riser 10 Make sure the springbar is in the position closest to the foot end of the reformer first gear Attach at least one red spring to keep the carriage in place 11 Install the shoulder rests back onto th...

Page 3: ... cross member The hole should be in the upper left position shown in Figure H Drill through the cross member holding the template in this position You can also tape the template into place if hard to hold or use a pencil to mark the holes when template is held in place remove template to drill marked hole 17 Install the two provided pulleys into the drilled holes in the head end cross member using...

Page 4: ...e other side of the Reformer IMPORTANT SAFETY NOTE Use of the Konnector system in a manner for which it is not intended may result in equipment damage and or injury to the user Intense cardio work utilizing jarring movements may overload the system Balanced Body is not responsible for injuries caused by equipment misuse Questions Call Balanced Body Technical Support at 1 800 PILATES US and Canada ...

Reviews: