Installing the Balanced Body
®
Rialto with Riser
Konnector
™
The Konnector is compatible with Balanced Body Rialto
Reformers ONLY. If you aren’t sure whether this system will
work with your equipment, please contact Balanced Body at
1-800-PILATES (US and Canada), or +1-916-388-2838 (all other
countries).
To view the installation podcast, please visit
www.pilates.com/instructions
TOOLS REQUIRED (NOT INCLUDED):
»
Power Drill
»
Phillips Head screw driver
PARTS LIST (INCLUDED):
ITEM
PART NO.
QTY
Konnector Rope
210-076
1
Tri-Loops (Grey)
210-061
2
Tri-Loops (Black) with pulleys
210-060
2
Twist lock flanged post ASM
616-401
2
Under carriage ASM
624-002
2
Pulley Assembly for Wood
620-083
2
Shoulder brackets
607-546
2
Riser tube assembly
607-547
1
Wood Template
607-542
1
#10 x 5/8 Phillips Pan Head Screw
GEN9143
4
1/4-20 x 1/2 Flat head screws black
GEN6671
4
1/4” Flat Washer
GEN9204
6
1/4-20 Hex Nut
GEN9056
6
1/4-20 Acorn Nut
GEN9181
2
5/16” Drill bit
TOL1059
1
3/32” (2.5 mm) Allen wrench
TOL1605
1
5/32” Allen wrench
GEN9282
1
7/16” Wrench
616-113
1
WARNING: Using the existing shoulder posts with a Konnector
system can cause the loops to fall off the posts during use
which may cause injury.
REMOVE ROPES, SHOULDER BRACKETS AND PADS
1. Remove the ropes and loops from your Reformer, they are no
longer needed.
2. Unthread each knob from the shoulder rest bracket by hand
and completely remove them from the shoulder rest bracket.
Remove the shoulder rest bracket from the carriage. Repeat
on the other side.
3. Using the provided small Allen wrench, remove the four flat
head screws from each shoulder bracket as shown in Figure
A. Keep theses screws, repeat on the other side.
WARNING: If you are only using some of the loops, the
unused loops MUST be stored on the flanged shoulder
posts.
1
2
3
4
Figure A
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-454 | 10.24.18
