Metro IQs with Library Wheels (702-019)
1. Using the 5/32” Allen key, remove the screws at the foot end
of the frame corresponding to the smaller holes in the library
wheel bracket. See figure J.
Note
: The bracket on the other
side uses the opposite screws.
2. Install the bracket, replace
the removed screws and
tighten. See Figure K.
Repeat on the other side.
INSTALLING AND
ADJUSTING THE
FOOTBAR
1. The Metro IQ footbar
can be adjusted to four
positions. Two positions are
created by installing the
footbar in one of two sets
of holes and another two by
reversing the footbar
(See Figure L).
Note
: If you find the footbar knobs difficult to pull out, wiggle
the footbar as you pull.
2. To install the footbar, pull one of the footbar knobs away from
the frame and rotate it 90 degrees and release it. Now it is
locked in the OUT position. Repeat on the other footbar knob
on the other side of the frame.
3. Insert the footbar into the desired holes, facing toward or away
from the carriage, to achieve your desired footbar position.
MAKE SURE THE FOOTBAR DROPS IN LEVEL AND
EVENLY SO THAT BOTH SIDES GO TO THE BOTTOM OF
THE HOLE. YOU MAY HAVE TO PUSH IT DOWN INTO
THE HOLES.
4. Now turn the footbar knobs either way, until they
automatically lock into place.
5. Grasp the footbar and push and pull it to make sure it is firmly
locked into position.
6. If the knob is correctly locked, it should only stick out slightly
further than it did when it was fully retracted.
USING THE SPRINGBAR
When hooking the springs on the springbar, make sure that the
ring of the spring is seated all the way down in to the prongs of
the springbar. See figure O.
Figure L
Figure J
Remove these two screws
Figure K
Footstrap hole
Figure M
The knob is locked
in the OUT position
Figure N
The knob is in the
LOCKED position
Figure O
5
