Balance 275947, User Manual

Page: 6 / 36

GETTING STARTED
This In-Out thermo mood-light clock was designed for easy set up. For
best operation, the following steps are required to be done in the proper
sequence.
1. Insert batteries to the main unit, it will automatically search the remote
sensors (while they are in effective transmission range) for 2 minutes
and then receive RCC signal for 10 minutes.
Note: Main unit can’t be programmed manually during RF searching
and RCC reception.
2. Insert batteries to the remote sensor and set it to desired channel by
pressing [CH] button.
3. The main unit will show the temperature reading of the remote sensor
in corresponding channel if it receives the RF signal and registers the
remote sensor successfully.
4. Position the remote unit and main unit within effective transmission
range, which is, in usual circumstances, is 30 meters (100 feet). The
remote sensor should be placed away from direct sunlight, rain or
snow.
WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE
Within 2 minutes of power up the main unit, activates the sensor as follows:
1. Insert the 2 AAA batteries into the sensor unit while the ‘ ’ icon in the
main unit is flashing to prompt the user that the main unit is in sensor
searching mode.
2. The LED on the front panel of the sensor will start flashing at a rate of
one time per around 2 seconds to indicate channel#1 is in use. While
the LED is flashing, press once the [CH] key will change the sensor
channel setting to #2. Keep toggle on [CH] key can change channel
setting up to #3. The LED is blinking at a frequency to indicate the
channel setting. i.e. continuous blinking 2 times indicates channel #2 is
selected.
If no key entry for 10 seconds, it will exit the channel setting mode and
transmit the RF signal of the temperature reading.
3. The main unit will show the temperature reading of the remote sensor
in corresponding channel if it receives the RF signal and registers the
remote sensor successfully.
4. The ‘ ’ icon in main unit will stop flashing after two minutes to prompt
user that it already exits sensor searching mode. In this case, the user
~ 6 ~
(EN)