25
STEP 6
Clean
the outside surf
aces with a s
tiff
brush to remove
any debris or dirt. Inspect the burners for any cracks or holes
that appear out of place. If cracks or holes are present replace
the Burner.
STEP 7
Clean the inside of the burners by inserting a s
tiff
wire or small bottle brush into the inlet portion of the Burner.
Compressed air may also be used to clean the burners by
blowing air into the inlet portion of the burner and the air will
flow out of the venturi holes.
STEP 8
Replace the burners by carefully inserting the burners
back into the fireboxes, taking care to avoid damaging the gas
valves when installing.
STEP 9
A
ft
er reassembling the appliance
, perf
orm a leak test
according to the instructions in this guide. Before placing
the Cooking Grates, Flame Tamers, Pizza Oven Box or other
cooktop on the fireboxes inspect the burner flames for proper
combustion.
STEP 10
Light the appliance according to the instructions
provided in this guide and look at the flame emitting from
the burners. A blue flame should emit consistently from each
venturi hole on the burners
[see Figure - 17].
The tips of the
flame may occasionaly flicker yellow while burning.
NOTE:
To inspect the flame with the Cooking Grates/Flame
Tamers and Pizza Oven Box/Griddle in place, first ignite the
burners according to the instructions provided in this guide
Then once the burners have ignited, look through the match
light hole in the side of the firebox to ensure the burners are lit
[see Figure - 17].
NOTE:
The flame from the center burner on the right side firebox
will not be as great as the perimeter burner.
STEP 11
Turn o
ff
the appliance according to the instructions
provided in this guide.
Figure - 17
Customer Service
For general inquiries, please email us at [email protected]
or call (855) 657-6836.
For North American customer service needs, such as obtaining replacement parts and
warranty claims, please email us at [email protected] or call (855) 657-6836.
CAUTION: The gas pressure regulator provided with this appliance must be used. Replace only
with regulator Model Number _______.
TYQ-10
