IL FORNO CLASSICO OVEN DESIGN & INSTALLATION GUIDE
24
DOUBLE OVENS WITH FRONT MOUNTED CONTROLS
When building your facade, provisions must be made for
accessing the following: (see sketch 16, page 25)
Front:
1. Hinged control access panels (one per oven)
2. Push-pull rods (two per oven)
3. Arched opening and lintel plate IL Forno only
4. Bake chamber door on lower oven
5. Combustion chamber doors both ovens
Left Side:
1. Side service access panels (optional &
recommended). Access to this panel eases
potential service access to the valve, booster
burner control, booster burner ignition module
and thermostat, however all components maybe
accessed though the front hinged control access
panels (difficult).
Rear:
1. Rear booster burner, flame sensor and igniter
- Provision should be considered for potential
service of these components. Following are 3
options:
A. Rear access panel (recommended).
B. Hinged or removable panel on the front of
the facade to allow the removal of flue cover
and inserts. This provides greater access for a
technician to service these components through
the front of the oven (see drawing below).
C. Through the arched bake chamber entrance
(difficult).
2. Electrical connection- IL Forno only
3. Gas connections - Each oven has a separate gas
connection
4. Minimum clearance for Service Technician and/or
for safe operation
Ventilation, Air Supply And Fire Protection:
See instructions on pages 14-19.
Figure 15B: Option “B” Access To Booster Burner
Summary of Contents for FC series
Page 1: ...BUILT BY CRAFTSMEN TESTED BY TIME SERIES FC IL FORNO CLASSICO DESIGN INSTALLATION GUIDE...
Page 31: ...29 NOTES...
Page 32: ...30 NOTES...
Page 33: ...31 NOTES...
