Baker Blue Streak Portable or Stationary Band Sawmill - Rev 2, 03/07;
WWW.BAKER-ONLINE.COM
14
Machine Positioning
(continued)
Manually unfold the log loader arms (see
Figure 25
on page 25).
Remove the hairpin cotter pin from the 3/4" transport pin holding the loader support outrigger
at the turnbuckle and lower the outrigger to the ground (see
Figure 14
and
14A
below).
Remove the hairpin cotter pin and 3/4" pin from the other end of the turnbuckle and then re-
attach the turnbuckle to the loader support outrigger leg with the 3/4" pin.
Attach the fork on the turnbuckle to the mill frame with the 3/4" pin.
Tighten the turnbuckle until the loader support outrigger foot rests firmly on the ground.
Remove the (2) head frame transport pins (see
Figure 25A
and
25B
on page 25).
Remove the transport pin from the clamp arm.
Remove the transport pin from the fence arms.
Attach the sawdust discharge chute.
Note:
Dust removal is recommended and this sawmill is equipped to accept a 6” pipe and a
minimum of 1,300 CFM should be used.
Inspect the mill ensuring all guards are in place and verify that the mill is safe to operate.
First remove pin and lower
outrigger to the ground; then
remove turnbuckle pin and re-
assemble per the picture to
the right
Tighten turnbuckle
until the outrigger
rests firmly on the
ground
Figure 14A
Figure 14
Step 1
Step 2
Step 3
Step 4
Step 5
