Baker 15579, Instruction Manual

Page: 10 / 21

10
Assembly
Please refer to the illustrations at the back of
the user instructions.
1. Secure the lid (2) to its sides (5) using 4
nuts (A).
2. Secure the rear panel of the lid (3) using
5 nuts (A).
3. Secure the front panel of the lid (1)
using 5 nuts (A).
4. Push the handle (7) into the holders (6).
5. Screw the holders securely to the lid
using 2 screws (F) on each side.
6. Screw the thermometer securely to the
lid.
7. Secure one leg (19, 23) to each side of
the grill unit (15) using 2 screws (B).
8. Secure one leg (19, 23) to each side of
the grill unit (15) using 2 screws (B). Fit
the bottom panel (22) using 2 screws (B)
through each leg.
9. Screw one wheel (21) to each of the legs
(19) using a wheel bolt (20), 2 washers
(C) and a nut (D).
10. Secure one side table (18) to each side
of the grill unit (15) using 6 screws (E) on
each side.
11. Secure the rear panel (12) and the sides
(14) to the grill unit using a total of 10
screws (E).
12. Fit the drip tray (17), � ame tamers (13),
griddle (10) and grill rack (11) into the
barbecue.
13. Secure the lid to the sides (14) using 2
screws (8). Place the warming rack on
the barbecue. Fit the buttons (16).
14. The barbecue is now ready for use.
Use
1. Turn the control knob clockwise to
position .
2. Open the lid before use.
3. Connect the regulator to the gas
bottle. Set the gas supply to ON on the
regulator. Use soapy water to check for
any gas leaks between the gas bottle
and the regulator.
4. Press the control knob down, and turn
it anticlockwise to the large position.
A clicking sound will be heard, and
the burner will ignite. If this does not
happen, repeat the procedure 3 or 4
times.
5. If the burner still does not ignite, wait 5
minutes and repeat point 4.
6. Once the burner has ignited, repeat
points 4 and 5 to ignite the other
burners.
7. Regulate the heat by turning the knob
to the High/Low position.
8. Turn off the regulator to turn off the
barbecue. Then turn all the control
knobs on the appliance clockwise to
position .
Warning: If a burner cannot be lit,
the control knobs must be turned to
(clockwise) and the regulator closed. Wait
� ve minutes before you try to light it again
by following the ignition procedure.