19
1. If engine is cold, start engine and allow to warm up 3 - 5 minutes.
2. Turn engine off allowing oil to settle to bottom of oil case.
3. With warm engine, NOT HOT, remove oil drain plug located at bottom of
engine and let oil drain into an approved collection container. DO NOT
PERFORM THIS PROCEDURE WHILE ENGINE IS HOT. SERIOUS BURNS
COULD RESULT FROM CONTACT WITH HOT OIL.
4. Dispose of used oil properly. For proper disposal procedures, contact
your local oil recycling center.
5. Re-install oil Plug.
6.
Refill engine with proper amount of oil and recheck amount by using dip
stick.
CHECk-UP OF SPARk PLUG
1. Remove spark plug cap and screw out spark
plug using plug wrench.
2. Clean spark plug all around or replace it if it is
corroded or there is too much deposit on it.
3. Regulate the gap of the spark plug with a feeler
gauge to .02 -.03in. (0.6-0.7mm).
4. The spark plug of the designated type should
be used.
Torch A7TC, NGk C7HSA, Denso U22FS-U,
Champion Z10YC, AC S102F, Autolite 2795.
.02 - .03 in.
(0.6~0.7mm)
CHANGING ENGINE OIL
Oil Plug
MAINTENANCE
