26
Baja
™
BA300
V I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized dealer. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on
each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be maintained
in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result
in loss of control, and overinflated tires may burst. Failure to maintain the psi/bar/kPa air pressure
rating indicated on the tires at all times may result in tire and/or wheel failure.
Regularly inspect your scooter’s tires for signs of wear.
WHEEL REPLACEMENT
Contact your authorized dealer for replacement tires.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tire tread, as this
may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Precautions must be taken when cleaning medical equipment/products to lower the risk of spreading
infection. This is to limit the spread of illness and other potentially infectious material (OPIM) (blood
components).
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your
scooter. Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
How to Clean/Disinfect Equipment:
Hard/Soft Surfaces
(Plastic shrouds, metal framing, seat fabric, tires, armrests and footplate mats, as
applicable)
●
For hard/soft surfaces, remove visible contamination if present.
{
For plastic and metal use Lysol®/Clorox® disinfecting spray/wipes and other qualified SARS-
CoV-2 disinfecting products.
{
For other vinyl surfaces, clean with vinyl safe disinfecting wipes or solutions
Suggested Disinfectants
Birex® SE Disinfectant, Bleach-Rite® Disinfecting Spray, Citrace® Germicide
Dispatch® Spray Hospital Cleaner Disinfectant with Bleach
Diluted Bleach Solution (10% dilution or less); Note: Bleach with pH factor between
7 and 9 is suitable; a product with a pH of 10.5 or higher may damage the vinyl
surface integrity over an extended period of time.
