12
CHANGING THE OIL
1. Remove the “Screw Plug” located at the bottom of the engine and let the
oil drain into an approved collection container. DO NOT PERFORM THIS
PROCEDURE WHILE THE ENGINE IS HOT. SERIOUS BURNS COULD RESULT
FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures, contact
your local oil recycling center.
3. Clean and replace the “Screw Plug” tightly. Torque to 18 ft.lb.
4. Refill the engine with 0.53 qt. (0.5L) of recommended oil and recheck the
amount of oil in the engine by using the oil gauge plug.
CHECk-UP OF SPARk PLUG
1. Remove the cap of spark plug and screw off
the spark plug using the plug wrench.
2. Clean the spark plug all around or replace it
if it is corroded or there is too much deposit
on it.
3. Regulate the gap of the spark plug to
.7mm - .79mm (.028”-.031”).
3. The spark plug of the designated type
should be used. The applicable type of
spark plug: Meiya - F7RTC Champion-
RN9YC, NGk - BPR6ES
.7mm - .79mm
(.028” - .031”)
Screw plug for oil draining