Bailey Infi 90 NICL01, Instruction

Page: 24 / 32

INTRODUCTION
I-E96-408A A - 1
APPENDIX A - NETWORK INTERFACE
SLAVE MODULE CONFIGURATION (INNIS01)
INTRODUCTION
The Network Interface Slave Module (INNIS01) uses the NICL01
to terminate its connection to an INFI-NET ring. A termination
cable (NKLS02) connects the NIS to the ICL. The ICL provides a
place to connect either coaxial or twinaxial cable from the com-
munication loop. This appendix contains figures and tables
that show the dipswitch and jumper locations on the NIS and
their settings. This information is provided as a quick reference
guide for personnel installing the NICL01. Figure
A-1 shows
the dipswitch locations on the NIS circuit board. Table A-1
shows how to set the NIS node address and ring number using
dipswitches SW1 and SW2. Table
A-2 lists the loop mode
dipswitch settings (SW3). Table A-3 shows examples of slave
address settings (SW4). Tables A-4 and A-5 list event and error
counter settings respectively, using dipswitch SW4. Figure A-2
shows the jumper settings (J1 through J6) that set the commu-
nication rate of the receiver analog circuit on the NIS. Refer to
the INFI-NET Communications Modules Instruction for more
detailed installation and configuration information.
NOTE: For all dipswitches:
OPEN or OFF position = logic 1
CLOSED or ON position = logic 0
Figure A-1. Network Interface Slave Module Switch and Jumper
Locations
GROUP A
LEDS
GROUP B
LEDS
USER-CONFIGURED
JUMPERS J1-J6
SW3
LOOP MODE
SW1
NODE ADDRESS
SW4
SLAVE ADDRESS
SW2
RING ADDRESS
EDGE
CONNECTORS
P1
P2
P3
T00493A