INSTALLATION
UNPACKING AND INSPECTION
2 - 2
I-E96-427B
®
UNPACKING AND INSPECTION
1. Examine the hardware immediately for shipping damage.
2. Notify the nearest Bailey Controls Company sales office of
any such damage.
3. File a claim for any damage with the transportation com-
pany that handled the shipment.
4. Use the original packing material and container to store the
hardware.
5. Store the hardware in an environment of good air quality,
free from temperature and moisture extremes.
SETUP/PHYSICAL INSTALLATION
This section explains how to configure and install the termina-
tion unit. You must configure the dipshunts before installing
the termination unit. There are four dipshunts, two for each
RS-232-C port. These dipshunts define the active handshake
lines. Each port can be configured as a DTE or DCE device.
Only port two can terminate a diagnostic terminal. The termi-
nation unit can interface with:
•
Devices.
Printer.
Sequence of events recorder.
IBM
®
PC.
COMPAQ
®
and compatible computers.
•
Terminals.
VT1XX.
ADM3.
VISUAL 50.
WYSE (WY50).
TELEVIDEO.
FALCO.
NOTES:
1.
The IMMFC04 and IMMFC05 Multi-Function Controller Mod-
ules use the termination unit for its link to control stations and for
connecting a redundant MFC module. They do not have serial com-
munication capabilities. Therefore, no dipshunts are required when
terminating the IMMFC04 or IMMFC05 modules.
2.
Only the IMMFC03 Multi-Function Controller Module drives the
TMF LEDs. The LEDs will not light when the termination unit is used
with an IMMFC04 or IMMFC05 Multi-Function Controller Module.
® IBM is a registered trademark of International Business Machines Corporation.
® COMPAQ is a registered trademark of COMPAQ Corporation.
