Bailey Infi 90 INPCI01, Instruction, Page: 28 / 43

INTRODUCTION
I-E96-620A 4 - 1
SECTION 4 - OPERATING PROCEDURES
INTRODUCTION
This section explains how to place the INPCI01 in operation. It
covers the use of module faceplate LEDs and controls.
INTERFACE START-UP
The interface is ready for normal operation upon installation.
Start up the interface by issuing a RESTART command through
the computer. Refer to the Enhanced CIU Programmer's Guide
for information about interface commands. Initially, there are
no points established in the point table and the loop is bypassed
until the computer gives the PCI the proper sequence of com-
mands. Once the PCI receives this sequence of commands, the
other nodes on the Plant Loop see it as an executing node.
SERIAL INTERFACE MODULE LEDs
The SIM faceplate has a set of four LEDs that count computer
commands and replies during normal operation (see Figure
4-1 ). These LEDs go through an exercise sequence and mem-
ory test before normal operation begins (see Figure 4-2 ).
Figure 4-1. SIM Faceplate
T00400A
INSIM01