INSTALLATION
PHYSICAL INSTALLATION
I-E96-317A
3 - 5
To insert the RIO:
1. Verify the slot assignment of the module.
2. Connect the NKTM01 or NKTU02 cable from the NIRL03
Termination Module, or the NKLM01 cable from the NTRL02/
03 Termination Unit, to the rear of the MMU backplane.
3. Slide the RIO into the slot; push until the rear edge connec-
tor (P3) is firmly seated in the cable plug, and the module latch
snaps into place on the bottom frame of the MMU.
NOTE: RIO Modules can be inserted while the INFI 90 System is
operating. When the RMP is inserted, the MFP reads, initializes, and
brings the RMP on-line without loss of system performance. Simi-
larly, an RSP begins normal start-up routines upon insertion, and
waits for the RMP to bring it on-line.To halt the RIO Module, press
the Stop switch on the faceplate. Wait until the red/green Status
LED becomes red. The stop is now complete, and the module may
be removed. Once stopped, the RIO Module must be removed and
reinserted to restart.
To halt the RIO Module, press the stop switch on the faceplate.
Wait until the red/green Status LED becomes red. The stop is
now complete, and the module may be removed. Once stopped,
the RIO Module must be removed and reinserted to restart.
WARNING
Disconnect power before installing dipshunts for slave mod-
ules on the MMU backplane (slave expander bus). Failure to do
so could result in severe or fatal shock.
AVERTISSEMENT
Couper l'alimentation avant d'installer les dipshunts sur la
plaque arriere du chassis de montage de modules (MMU).
Toute negligence a cet egard constitue un risque de choc pou-
vant entrainer des blessures graves, voire moretiles.
WARNING
The RIO module MUST be stopped before removal. The output
status of slaves may incorrectly change if an active RIO is
removed before being properly stopped.
AVERTISSEMENT
Le module RIO doit place en mode arret avant d'etre retire du
chassis. L'etatdes sorties des modules asservis pourrait
changer de facon erronee si un module RIO actif est retire
avant d'etre place en mode arret.
