Bailey IMCIS02, Instruction

Page: 30 / 58

INSTALLATION
SETUP/PHYSICAL INSTALLATION
3 - 4 WBPEEUI240755B0
®
Analog Output Default Jumpers (J7, J8, J12, J14, J10, J16)
The analog output default jumpers determine the I/O module
analog output default values. These are the values or levels for
the analog outputs during system start-up (power up) or bus
fault error (time-out).
Select either a zero percent or 100 percent power up output.
Selecting zero percent will output four milliamps or one VDC;
selecting 100 percent will output 20 milliamps or five VDC.
If the bus fault timer expires (times out), the digital outputs
de-energize and the analog outputs change to the default value
selected. A time-out occurs when the I/O module does not
receive a clock signal from the MFP. The time-out options are
to
hold or go to power up state . The outputs will stay at their
current values during a time-out if the hold option is selected;
they will change to the power up values (zero or 100 percent) if
the go to power up state is selected.
Refer to Figure 3-1 for location of the jumpers and Table 3-2 for
jumper settings.
NOTE: Jumpers J10 and J16 are not required.
28 0 1 1 1 0 0 46 1 0 1 1 1 0
29 0 1 1 1 0 1 47 1 0 1 1 1 1
30 0 1 1 1 1 0 48 1 1 0 0 0 0
31 0 1 1 1 1 1 49 1 1 0 0 0 1
32 1 0 0 0 0 0 50 1 1 0 0 1 0
33 1 0 0 0 0 1 51 1 1 0 0 1 1
34 1 0 0 0 1 0 52 1 1 0 1 0 0
35 1 0 0 0 1 1 53 1 1 0 1 0 1
36 1 0 0 1 0 0 54 1 1 0 1 1 0
37 1 0 0 1 0 1 55 1 1 0 1 1 1
38 1 0 0 1 1 0 56 1 1 1 0 0 0
39 1 0 0 1 1 1 57 1 1 1 0 0 1
40 1 0 1 0 0 0 58 1 1 1 0 1 0
41 1 0 1 0 0 1 59 1 1 1 0 1 1
42 1 0 1 0 1 0 60 1 1 1 1 0 0
43 1 0 1 0 1 1 61 1 1 1 1 0 1
44 1 0 1 1 0 0 62 1 1 1 1 1 0
45 1 0 1 1 0 1 63 1 1 1 1 1 1
1 = OPEN; 0 = CLOSED
Table 3-1. S1 Address Switch Settings
(continued)
ADDR
MSB LSB
ADDR
MSB LSB
3 4 5 6 7 8 3 4 5 6 7 8