43
43
Miter Cross Cutting
This operation is the same as cross cutting, except
the miter gauge is set to an angle other than 0.
After changing the blade angle, verify the alignment
of the guard and splitter and verify that there is
clearance with the saw blade.
Hold the work piece firmly against the miter gauge
and feed the workpiece slowly into the blade to
prevent it from moving during the cut.
Blade Tilt/Bevel Cuts
When the blade tilt stop bolts are properly
adjusted, the blade tilt handwheel allows the
operator to tilt the blade to the left, between 0°
and 45°. This is used most often when cutting
bevels, compound miters or chamfers.
WARNING:
Turn OFF the saw and allow the blade to come to a complete
stop before removing the cut-off piece. Failure to follow this warning could result in
serious personal injury.
Summary of Contents for TS-1044H
Page 58: ...55 55 TABLE SAW PARTS DIAGRAMS...
Page 59: ...56 56...
Page 60: ...57 57...
Page 61: ...58 58...
