Baileigh HSP-30A, Operator'S Manual

Page: 24 / 40

22
22
OPERATION
1. Select a set of holes where you want to position the bed frame.
2. Have an assistant raise the frame to a point slightly higher than the holes so that the two bed
frame pins (9) can be inserted into the holes.
3. Secure the four wire clips (10) to the pins and then lower the frame so it rests squarely on
the pins.
4. Place the two heel blocks (12) on the frame. They can be used with the flat side up or the V-
block side up. Always push the pins down.
Note: The heel blocks should always be used as a pair, not individually.
Sequence of Operation
1. Insert the piece part into the V-blocks or onto the flat blocks.
2. Close the release valve by turning it clockwise (cw) until it is off.
3. Connect the quick air valve to a 120 psi. (.83 MPa) air source.
4. Press the lever on the air valve to let the pump work until the serrated saddle (14) nears the
piece part, then turn off the valve. (When an air source is unavailable, pump the handle (31)
until the serrated saddle nears the piece part.)
5. Align the piece part to the ram to ensure center loading.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
NOTICE: NEVER lift or lower the bed with tooling or material or pressure from the ram on
the bed. This will damage the machine voiding the warranty.