26
26
Removing Tooling From Spindle
1. Disconnect machine from the power source.
2. Place a piece of wood on the table for protection.
3. Position the worktable
approximately 10” under the bit and
lower the spindle about 6”.
4. Place the drift key (AM) into the slot (AN) of the quill and tap the
end of the drift key with a hammer until the bit or chuck arbor
falls out.
AM
AN
Summary of Contents for DP-1250VS
