Baileigh BS-916M, Operator'S Manual

Page: 34 / 52

31
31
LUBRICATION AND MAINTENANCE
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
Note: Proper maintenance can increase the life expectancy of your machine.
Blade Removal and Installation
When your machine was shipped, a blade was supplied and installed into the saw. When
selecting a new blade refer to the selection of sawblades. The machine requires a blade 1” x
0.032” x 130”. (27 x 0.9 x 3300mm).
1. Disconnect the machine from the power
source.
2.
Raise the saw frame about 6”-8” (152-
203mm) turn the descent ON/OFF valve to
the OFF position.
3. Open both wheel covers and remove the top
blade cover.
4. Clean the chip out of the bow and blade
track.
5. Release blade tension by turning the blade
tension handwheel counter-clockwise.
6. Slide left blade guide arm to the right as far as possible.
7. Remove the blade from both wheels and out of each blade guide.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.