Baileigh BS-300M, Operator'S Manual

Page: 19 / 56

16
16
Material Stop
1. Install the material stop rod into the front of the saw
table and fully tighten.
2. Install the stop contact and extension assembly
onto the rod and tighten each in a position that will
not interfere with the remaining setup.
Motor, Belt Guard, and Belt
1. Remove the nut and washer from the motor pivot
pin.
2. Install the motor on the pivot pin as shown so that
the pulleys are in line with each other.
3. Raise the motor slightly and connect the belt
tension adjuster to the motor mounting plate. Do
not tighten at this time.