Baileigh Industrial MB-4X2, Operator'S Manual

Page: 30 / 59

27
completed. When the machine reaches the final degree setting the auto sequence will take
over and start with retracting the mandrel, then the pressure die and finally the clamp die.
4. You are now ready to advance the material for the next bend.
MULTI BEND MODE
1. In Multi Bend mode, the user is able to
program multiple bend angles and the
machine will run the programs in succession.
(Fig. 12)
2. The programming is very simple, from the
multi bend scre
en, select “View /Edit
Programs” tab. A screen will pop up showing
the available parameters for changing.
3. You can set the name of the program; bend
angle, spring back, linear position and
rotation. Once the values are entered, select
“manage” and you can either “save” or “save
and run” if you select “save and run”, it will
put you back into the multi-bend screen.
(Fig. 13)
4. After a program is created and selected, you
can run the program and bend the part,
again,
“Never activate the auto bend
sequence witho
ut material installed!!”
5. Install material and position the start of bend
to the “0” or centerline axis of the machine.
6.
Press the “auto sequence” button and agree
if you already made successful bends. The
axis’ will automatically clamp just like described in the single bend mode.
7.
Press the forward pedal to produce the bend, once at the final degree, the axis’ will open up.
Advance the material and rotate as needed.
8. Return the clamp swing arm manually back to home.
9.
Reverse the bender using the “reverse” pedal. Caution! Be sure the material is advanced
enough to allow reversal of the bend die.
10. Position the material for the next bend in line, and press the forward pedal, this will begin the
auto sequence again. The control will have automatically switched to the next bend in line.
11. Repeat the previous steps, as needed. When the final bend in sequence is made, the control
will cycle to the first bend and repeat.