Baileigh Industrial DP-1850G, Operator'S Manual

Page: 28 / 52

25
25
•
When the feed clutch engages, the green indicator
light (D) above the tachometer will turn on and the
clutch will start to pull the feed handle.
•
Release the handle and the switch and allow the
clutch to provide the down force.
•
At any time the feed may be stopped by:
o
Pressing any one of the feed buttons (C)
o
Pressing the Drill Stop button.
o
Pressing the E-Stop.
•
The down feed will stop when it reaches the end of its travel as set by the depth stop.
Table Adjustment
The drill press has two work table. The base table
which is a fixed position table which does allow for
larger size material and the movable table which has
several ways to be positioned and adjusted. Both
tables have T-slots to be used to secure the material
and or vise to clamp and hold the work piece from
moving during the machining process.
The movable work table may be positioned by;
•
Lift the column clamp (A) to unlock the table arm
from the column.
•
Rotate the table and arm as an assembly around
the column or use the hand crank (B) to raise or
lower the table and arm assembly.
•
Always lock the column clamp before machining
any material.
•
To swivel the table on the center post, unlock the
center clamp (C) and rotate the table as desired
and then lock the clamp
•
To rotate the table horizontally on the arm, Support
the table to prevent unintended movement.
•
Loosen the four clamping nuts (D), pull the lock pin
(E, opposite side) and tilt the table ±45
° as desired.
•
Be sure to tighten the clamping nuts before
machining.
D
C
A
C
D
B
E