22
22
9. Remove the (3) bolts holding on the bearing block (
E
).
10. Remove the two V-belts and replace with new ones.
11. Re-install the bearing block.
12. Tension the motor belt so that when pressed, in the middle of its travel, it has no more than
one belt’s width of movement. Tighten the (4) motor adjustment nuts. (Check belt alignment
and re-adjust if necessary).
13. Place the sander / grinder back onto the stand, replace the (4) bolts and nuts, and tighten
securely.
14. Re-tighten the adjustment bolts for the auxiliary V-belt. (Check alignment)
15. Re-install the small V-belt belt guard.
16. Install the tables back onto the sander / grinder.
17. Verify that all parts have been re-installed and tightened properly. Make sure no loose tools
have been left on the machine.
18. Re-establish electrical power to the
DBG-106
sander / grinder.
figure 14
E
