18
18
To set the arm to an angle between horizontal and
vertical use a machinist’s protractor. Re-tighten both
lock bolts to secure the arm.
(Fig. 3) shows the table still attached. It can be pivoted
if desired or completely removed depending on the
intended application.
Adjusting the Disc Sander Table
Loosen the locking knob underneath the table as
shown in (fig. 4). Using the pointer and scale, set
the angle between 0° and 45° downward as
needed. Lock the knob when the desired angle is
shown on the scale.
The distance between the disc and the edge of the table
can also be adjusted by loosening bolt (
A
) and sliding
the table assembly either in or out. The table can also
be removed when replacing the sanding / grinding disc.
Using the Miter Gauge
The miter gauge can be used on either the disc or belt
surfaces to sand or grind accurate angles on the piece
part. When using the gauge alone, you can sand or
grind a single angle. However, by tilting the table and
CAUTION:
NEVER ADJUST THE
ARM
ANGLE
WHILE
THE
SANDER
IS
RUNNING. ALWAYS TURN THE MOTOR OFF
BEFORE ADJUSTING THE ARM ANGLE.
CAUTION:
NEVER ADJUST
THE TABLE ANGLE WHILE THE SANDER
IS RUNNING. ALWAYS TURN THE MOTOR
OFF BEFORE ADJUSTING THE TABLE
ANGLE.
figure 3
figure 4
A
figure 5
