19
19
using the miter gauge in combination with the table tilt, it is
possible to do compound angles as well.
When grinding a compound angle you should always check
the accuracy of your setup by sanding a piece of scrap
material before doing any finish sanding on the actual work
piece.
MAINTENANCE
Sanding / Grinding Belt Replacement
1. Disconnect power to the machine to prevent accidental
start-ups. If the machine is plugged into an outlet,
unplug it. If the machine is hardwired to a branch circuit
with a junction box, remove the fuse or trip the circuit
breaker to the branch.
2. Take off the bottom cover by removing (8) screws, and
the top end cover held on with (4) screws. (see fig. 6)
3. Lower the arm to a horizontal position and take off the
plastic dust chute (
B
) by removing two screws as
indicated in (fig. 7).
4. Release the belt tension by sliding the tension handle
to the right (See fig. 8).
WARNING:
Make sure the electrical
disconnect is OFF before working on the machine.
Maintenance should be performed on a regular basis
by qualified personnel.
Always follow proper safety precautions when
working on or around any machinery.
figure 7
figure 8
figure 6
B
