Baileigh Industrial BS-210M, Operator'S Manual

Page: 18 / 60

15
15
Machine Base
After assembly, the machine base becomes the structure that
supports the saw bow, the vise, the coolant pump, the bar stop,
and the swing arm.
Quick Clamp Vise
Place the piece part between the vise jaws and have it rest next to
the fixed vise jaw. Rotate the hand wheel (A) clockwise (cw) to
close the front jaw onto the piece and tighten. Rotate the hand
wheel counterclockwise (ccw) to release. Vise lever (B) can be
used to quickly lock and release the piece part by allowing a small
gap between the vise and part. Then rotate lever (B)
counterclockwise (ccw) to lock and clockwise (cw) to release.
Cutting Angle Adjustment
Angles can be cut up to 60°. Unlock the rotating saw head by
pushing the miter lock lever (R) to the left. Rotate the saw head to
the desired angle as shown on the angle indicator (Q). Lock the saw
head by pushing the lock lever (R) to the right.
IMPORTANT: Check that the saw blade clears all parts of the vise assembly before
cutting. The blade can strike parts of the assembly (especially during miter cuts) if not properly
adjusted. Make sure saw bow is in a down or horizontal position when moving or mitering, to
avoid tipping over machine.
A
B
R
Q