32
32
Bending Leaf Edge Alignment
Bending accuracy is dependent on the top surface of the bending leaf
and the attached bending wing being flush with the top face of the
clamping block when the bending leaf is in the lowered position.
1. Adjust bending leaf center truss nut (E) up or down as needed
until the center of the bending leaf is perfectly aligned (on the
same plane) with the clamping leaf edge.
2. Loosen the hinge to leaf bolts (F) only slightly to allow for the leaf
to move with the adjusting bolt (G).
3. Adjust bending leaf ends with hinge adjustment bolts (G) up or
down as needed until the ends of the bending leaf are perfectly
aligned (on the same plane) with the clamping leaf edge.
4. Repeat these steps as needed until the entire length of the
bending leaf is perfectly aligned (on the same plane) with the
clamping leaf edge.
5. Tighten the hinge bolts (F) after adjustment.
G
F
figure 29
