11
10.
When conditions are met and your safety
representative has reviewed all safety
requirements, plug in the power cord to a
properly grounded power source 110 volts,
15amp service (see fig. 3 for proper cord
sizing).
11.
After 15 minutes check the pipe
temperature with temperature sticks or
other devices mentioned in section 8.
Adjust thermostat up (clockwise) or down
(counter clockwise) to achieve desired
temperature using an insulated standard
flat screw driver.
12.
After desired temperature is achieved and
has been approved by Quality Assurance,
you can begin to weld.
Hot Coils
®
can
easily be slid to give you the required
access room for welding.
Note -
use anti splatter spray or paste on
outside shell of Hot Coils
®
to avoid splatter
sticking to stainless.
CAUTION
The heater is instantly on when plugged into a
power source, as there is no On/Off switch.
Maximum internal temperature is
550ºF/286ºC.
CAUTION
CAUTION
HOT SURFACE
Contact with skin may cause
burns.
DO NOT TOUCH
Use proper PPE when
handling the
Hot Coils
®
.
When Required Work Is Complete
1.
Unplug power cord from power source.
2.
Allow a cool off period until it is safe to
remone the
Hot Coil
®
.
3.
Remove pin from the latch and open the
heater coil (fig.8)
Burn
Hazard
Burn
Hazard
Fig. 8
