Nova-436 Outdoor LTE TDD Base Station Installation Guide
19
35mm ~ 50mm. A typical case is to use the 50mm-diameter round-steel-made pole
(with details depending on the specific antenna type).
Make sure that the top of pole and the clamp beneath the antenna are at the same
level, after installing the omnidirectional outdoor antenna on the pole.
Make sure that the antenna is high enough to meet the coverage requirement, and
that the antenna top falls within the 45 degrees safety angle towards the lightening
rod, as shown in Figure 3-4. In principle, no lightening rod can be welded to pole (no
metal object is allowed within 1m of the horizontal direction of the omnidirectional
antennas), when installing the omnidirectional antennas. Instead, an independent
lightening rod should be settled between the two poles, where the lightening rod
must be high enough to keep all antennas under its protection cover.
Figure 3-4 Omnidirectional Antenna Installation (1)
In case is impossible to install an independent lightning rod due to environmental
limitations, the installation method shown in Figure 3-5 can be used. Be aware that the
pole supporting the lightening rod should be kept at least 1m away from the
omnidirectional outdoor antennas.
