6
www.stairslight.com
Diagram: Ceiling lighting
The next picture shows a solution where the exit No. 20 is connected to three 12V LED lights
placed on the ceiling above the stairs. The driver will be turning it on with the first step and turn off after
about 2 seconds from the extinction of the last step. Of course, you can use any other light source
with the voltage of 12V, depending on the design of the stairs, in place of ceiling lamps.
When designing the connections between the controller and LED points, please include your
current flowing in the circuit and select the appropriate type of wiring. Plus supply line for 12V LED
strips or LED lights should have a much larger cross-section than the cables between the controller
and the LED strips.
ATTENTION! You cannot connect the AC to 5V plus (+) and minus (-) outputs. These con-
tacts are used for low-voltage power sensors.
Installation must be carried out very carefully and securely to avoid loosening of wires or short
circuits between them. LED strip wires should be soldered. We do not recommend using special
sockets and plugs, because after a while, due to the movements of the stairs, they are loose and
may lose contact.
