15
www.stairslight.com
the parameter takes place after a release of the button after the desired number of pulsees or just
after the end of the flickering. During the flickering, if the
SETUP
button is not pressed, after a short
time of the
LED
fading out, flickering of the next parameter will appear and so on until the end of the
setting mode. If the given flicker is omitted, the corresponding parameter will not be changed. This
allows you to set only one parameter, without any of the others. Notice: if the
SETUP
button is pres-
sed during the flickering and released immediately after it, but before the first pulse, the parameter
will return to the factory setting.
After setting the selected parameter, the controller immediately returns to a stand-by state, waiting
for a signal from pulse sensors or push buttons. There are no flickers for other parameters. To set
another parameter, use of the
SET
button again.
Description of parameters
Flickering 1 – Count of stairs.
The controller is factory-set for 15 steps. This can be changed with this parameter. The range is
from 5 to 23 steps. To change the number of steps, press and hold the SET button during the first
flickering. You should release the button after the right number of flicks. Eg., to set 18 steps, release
the button after 18th flick.
Flickering 2 – Count of rails.
The controller is factory-disabled for lighting the railing. You can turn on one or two rails. Note:
two rails should be set only if in the entire staircase there are handrails on both sides. In other cases,
such as one handrail divided into two sections, set the operation to one handrail! Releasing the button
after the first slow pulse sets the lighting for one rail, and letting go after the second pulse – sets
the lighting for two rails. Releasing the button after the end of flickering and before the first pulse
switches off the backlight railing.
Setting a single parameter
