Page 14/37
Operating Instructions
BA 373-E66
Technical specifications subject to change
W. Bälz & Sohn GmbH & Co.
Koepffstrasse 5
74076 Heilbronn
Germany
Phone +49 (0)7131 15 00 0
Fax +49 (0)7131 15 00 21
www.baelz.de
Observe copyright protection DIN 34
Use an insulated screwdriver to actuate the switching rolls of the DE switches and WE switches as shown in the
connection diagram and check that the respective switches actually switch off the motor.
If necessary, change the motor supply jumpers installed.
Risk of electric shock!
6. ACCESSORIES
When mounting, always make sure that the connecting rod is extended.
Disconnect the actuator from power before starting any work!
Attention: limit switches can only be installed when mounted "with a potentiometer"
(main board)!
6.1 Switching and signalling unit
This actuator can be equipped with a switching and signalling unit
[114]
.
This unit includes:
● 2 travel-dependent switches "WE"– S3 and S4
[282]
which can be used as limit switches or signal switches
(as special version also available with 4 WE)
● 1 potentiometer
[283]
as signalling module
Figure 8: Switching/signalling unit Figure 9: Switching/signalling unit, side view
Attention
Danger
Danger
Attention
