2
■
TABLE OF CONTENTS
Page
Unpacking and Inspection .................................................. 2
INSTALLATION
Surface Mounting or Pipe Mounting .................................. 3
Panel Mount ......................................................................... 3
Wiring Precautions & Procedures ...................................... 3
Battery Installation ............................................................. 3
AC Power Connections ........................................................ 3
Transmitter Connections (AR/t & RTR)..............................
4
Lockout Signal Connections ............................................... 4
Remote Start & Stop Connections ..................................... 4
Connecting to Other Equipment ........................................ 5
OPERATION
Forced Regeneration ........................................................... 6
Aborting Regeneration cycle .............................................. 6
Overriding Preset Batch Value ........................................... 6
PROGRAMMING
General Programming Procedures ..................................... 5
Setting For Manual/Auto Operation ................................... 5
Setting AR/e to Type & Size of Meter ................................ 5
Batch Size ............................................................................ 6
Output Signal Duration ....................................................... 6
Start-up Check List ............................................................. 6
TROUBLESHOOTING
Self-test Procedure .............................................................. 6
Replacement Parts ............................................................... 6
Troubleshooting Chart ........................................................ 7
To avoid damage in transit, Badger prod-
ucts are shipped to the customer in spe-
cial shipping containers. Upon receipt of
the product, perform the following un-
packing and inspection procedures.
Note: If damage to the shipping con-
tainer is evident upon receipt, request the carrier to be
present when the product is unpacked.
a. Carefully open the shipping container following any in-
structions that may be marked on the box. Remove all cushion-
ing material surrounding the product and carefully lift the
product from the container.
Retain carton and packing material for use in re-shipment
or storage of unit.
b. Visually inspect the product and applicable accessories for
any physical damage such as scratches, loose or broken parts
or any other sign of damage that may have occurred during
shipment.
Note: If damage is found, request an inspection by the
carrier's agent within 48 hours of delivery and file a claim
with the carrier. A claim for equipment damaged in transit
is the sole responsibility of the customer.
■
UNPACKING & INSPECTION
■
SCOPE OF THE MANUAL
This manual contains information concerning the installation,
operation and maintenance of the AR/e with AR/t or RTR Water
Conditioning Control System. To ensure proper performance
of the system, the instructions given in this manual should be
thoroughly understood and followed.
Keep the manual in a readily, accessible location for future
reference.
Changes and additions to the original edition of this manual will
be covered by a "Change Notice" supplied with the manual. The
change notice will explain any differences between the product
received and the product described in this manual.
■
INSTALLATION
The AR System consists of a Badger Disc
or Turbo meter with the AR/t or RTR
pulse transmitter and the AR/e Condi-
tioning Controller. Normally, the trans-
mitter will be mounted on the meter. It
does not require any additional mount-
ing procedure. All transmitters use a
simple bayonet mount and a seal screw to
attach to the meter.
Note: Always be sure to match the transmitter to the proper
meter. A red dot on the AR/t transmitter dial indicates the
meter model and size for which the transmitter is intended.
The RTR dial face has the model designation of the appro-
priate meter.
