Winch Installation
|
PAGE 6
Step
14
Locate the winch control switch harness and the included dash switch. Replacing the switch is optional, but will
allow the switch to be installed directly into the dash of the UTV (Figure 19).
Step
15
Cut off the factory switch and strip the cable and wires in order to add female spade connectors (Figure 20).
Step
16
Add a piggy-back connector to the lone red twire (Figure 21).
Figure 19: Switch Harness & Dash Switch
Figure 20: Female Spade Connectors
Figure 21: Piggy Back Connector on Red Wire
