Bitstorm Inc.
Bad Boy Xtreme N & MJ
14
www.bitstorm.com
into the browser’s address bar. Refer to Chapter 3 - Operation.
3. Multiple Wi-Fi devices. If system does not include optional Unleashed, ensure
the computer’s built-in Wi-Fi is turned off. Refer to your computer’s manual.
4. Incorrect Xtreme URL address entered. Ensure you type ‘xtreme.wifi’ - no ‘e’.
Unable To Connect To Xtreme’s Management Tool
1. No power. Refer to ‘LAN LED Not Illuminating’.
2. Cable not connected. Refer to ‘LAN LED Not Illuminating’.
3. Can’t find server. If system does not include optional Unleashed, ensure the
computer’s built-in Wi-Fi is turned off. Refer to your computer’s manual.
4. Incorrect IP address. If system does not include optional Unleashed, ensure
your computer’s Ethernet port is using DHCP.
5. Incorrect UID and PWD entered. Check that the user ID and password you are
using are correct.
LAN LED Blinks At A High Rate
1. Cabling issue related to Junction Box. Ensure that all of the wires are punched
down to the very bottom of each contact in the Junction Box.
2. Incomplete electrical connection. Also refer to
LAN LED Not Illuminating
Settings Are Not Being Retained
1. Low voltage. Ensure that the power being supplied to Xtreme is as required by
your Power Adapter.
2. Not clicking ‘Apply’. Ensure that when a new hotspot is selected or setting
changes are made and that the ‘Apply’ button is clicked.
Weak Signal Strength
1. Weak hotspot. Check that the signal being connected to is strong. Obstructions
can temporarily get into the line-of-sight to the hotspot.
2. Antenna connector loose. Check that the antenna N-Female connector is se-
curely connected to Xtreme. Do not over tighten.
Testing Cable With An Ohm Meter
Ensure that power is off and computer (or Unleashed) is unplugged.
With Xtreme Connected
Check the following for a reading of <20 Ohms:
Blue to Blue / White
Brown to Brown / White
Any combination of Green, Green / White, Orange and Orange / White
Check the following combinations for a reading of ~5K Ohms:
Green, Green / White, Orange and Orange / White to Brown and Brown / White
With Xtreme Unplugged
Check the following for a reading of <20 Ohms:
Blue to Blue / White
Brown to Brown / White
Check the following for open circuit reading:
Green, Green / White, Orange and Orange / White to any other wire
Blue and Blue / White to Brown and Brown / White
If any value is outside what is indicated, investigate as to cause and correct.
Reset Button Located On Xtreme
The Reset button on the bottom of Xtreme next to the connector is a multi-function
button and should not be used except under the direction of support staff. Improper
use of this button could render your device inoperative. If this occurs, you may be
