Bitstorm Inc.
Bad Boy Xtreme N & MJ
12
www.bitstorm.com
Appendix C - Power Injector DUO Specifications
M-POE-DUO-S15.5
Injector Power Input:
5-30 Vdc
Injector Power Output:
15.5 Vdc, 1A max
Output Ripple:
< 80 mV
Output Short Circuit Protected:
Yes – protection circuit limited to 5A max
Power Reverse Polarity Protection:
Yes – yellow LED indication
Thermal Shutdown:
Yes
Efficiency:
up to 90%
Port 2 Power Injecting (PoE):
Yes – enabled / disabled by jumpers
Port PoE Pins:
Po) 4 & 5, Negative(-) 7 & 8
Startup Delay:
approx. 2 to 4 seconds
AC Adapter:
Included, 100-240 Vac, North American
DC Power Cable:
Included
Dimensions:
3.6" x 2.6" x 1.1" (9.2cm x 6.6cm x 2.8cm)
Remote Reset:
Yes - Button on side
A reset causes settings to be restored to a known state. For example, this can
be useful to restore username or password to default values. To perform a
Reset operation, do the following (read all instructions first):
1) The DUO will send a signal to perform a remote reset to all connected
devices. Unplug the cables of any device that you do
NOT
want to have
reset. Leave connected the device(s) that you wish to have reset.
2) Power on and ensure devices have had enough time to fully start.
3) Using a small screw driver or other flat ended,
non sharp
object, insert it
into the slot until you feel and hear a click.
Note: Do not use force!
4) Hold the reset button depressed for at least 30 seconds and then release.
If the button becomes unpressed during this time, cycle the system off and
on, and wait 30 seconds before trying again. Disregard any LED patterns
displayed on connected devices.
5) Power off. Tip: You can simp-
ly remove the barrel power
plug from DUO. Verify that
the Port’s green power LED
turns off.
6) Reconnect power and wait
sufficient time for the devices
to fully restart. Your Xtreme
should now be restored to
original default settings.
Appendix D - Remote Reset
